Saltar al contenido principal

Cambios al paso #2

Editado por JBS

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

[* black] Insert a flat metal spudger in the gap between the rubber outer ring on the front panel assembly and the black plastic rear case near the USB connector.
[* black] Pryblue] Gently pry the front panel assembly up fromand at the same time use a second spudger to release the first clip (red box).
[* blue] During the next step and everytime you release a clip, the clip will NOT be showing above the edge of
the rear case,case.
[* blue] While upward pressure is
being careful notapplied to damage the LCD orfront panel, use the glass panelsecond spudger to release the clip by prying it towards the edge of the rear case.
[* blue] You will feel the front panel raise slightly as soon as the clip is released
.
[* icon_caution] As you work through the following steps, insert your metal spudger and prybe careful not to damage the front panel up, butLCD or the glass panel. Also, do not try to slide the spudger along the gap you're creating. Alwayscreating, instead always remove your spudger, then insertspudger and re-insert it at another spot and pry upwardspot.
[* black] Pryblue] Gently pry the front panel assembly up fromand at the same time use a second spudger to release the first clip (red box).
[* blue] During the next step and everytime you release a clip, the clip will NOT be showing above the edge of
the rear case,case.
[* blue] While upward pressure is
being careful notapplied to damage the LCD orfront panel, use the glass panelsecond spudger to release the clip by prying it towards the edge of the rear case.
[* blue] You will feel the front panel raise slightly as soon as the clip is released
.
[* icon_caution] As you work through the following steps, insert your metal spudger and prybe careful not to damage the front panel up, butLCD or the glass panel. Also, do not try to slide the spudger along the gap you're creating. Alwayscreating, instead always remove your spudger, then insertspudger and re-insert it at another spot and pry upwardspot.

Imagen 1

Versión Antigua

Nueva Versión