Saltar al contenido principal

Cambios a Paso #6

Editado por Andrew Bookholt

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* red] Insert a 1.2 mm Phillips screw into each of the outer holes drilled into the trackpad (two screws total).
[* icon_caution] You'll install the rest in a bit.
[* icon_note] When you tightenTighten the two screws, make them tight and then back them out about a quarter turn to aid in aligning your trackpad during the next few steps.
[* icon_note] When you tightenTighten the two screws, make them tight and then back them out about a quarter turn to aid in aligning your trackpad during the next few steps.