Saltar al contenido principal

Changes to Step #4

Editado por Howg

Aprobación pendiente

Borrada
Añadida
Sin cambios

Step Lines

[* black] Remove the following 3 screws:
[* red] Two 1.5 mm Phillips #00 screws, one on either side of the dock connector.
[* orange] One 2.4 mm Phillips #00 screw near the ribbon cable labeled "4." !) (then spudge all over the floor and roll around in it! Youre done!)
[* orange] One 2.4 mm Phillips #00 screw near the ribbon cable labeled "4." !) (then spudge all over the floor and roll around in it! Youre done!)