Saltar al contenido principal

Cambios a Paso #14

Editado por Sam Goldheart

Edicion aprobada por Sam Goldheart

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Use a spudger to gently pry up the end of the logic board closest to the dock connector.
[* icon_caution] There is a small golden grounding tab on logic board adjacent to the 'do not remove sticker'.red] Be VERY careful this does not to snag the grounding clip on the side of the case when prying up the logic board; it breaks easily. If you have signal problems after removing the logic board, check this ground tab.
[* icon_caution] There is a small golden grounding tab on logic board adjacent to the 'do not remove sticker'.red] Be VERY careful this does not to snag the grounding clip on the side of the case when prying up the logic board; it breaks easily. If you have signal problems after removing the logic board, check this ground tab.
[* icon_note] If the board won't lift up, double check to make sure all the screws securing the logic board have been removed.

Imagen 2

Ninguna imagen anterior

Añadido