Saltar al contenido principal

Cambios al paso #4

Editado por Sam Goldheart

Edicion aprobada por Sam Goldheart

Antes
Después
Sin cambios

Líneas de Paso

-[* black] Temporarily put the LCD back into the body of the iPad 2 and remove the front panel, being careful not to damage the digitizer cable in the process.
+[* icon_note] In order to remove the front panel assembly, the ribbon cable needs to slide out between the case and the LCD. You'll need to move the LCD to make some room.
+ [* icon_caution] Be very careful when moving the LCD, and do not attempt to remove it from the iPad—its cable will remain connected while it is rotated over.
+[* black] Lift the LCD from its long edge farthest from the digitizer cable and gently flip it toward the rear case—like closing a book.
+[* black] While holding the LCD up, gently slide the front panel away from the iPad. Be careful not to snag the digitizer cable on the rear case or LCD.
+ [* black] Set the LCD back into the body for safekeeping.

Imagen 1

Versión Antigua

Nueva Versión

Imagen 2

Ninguna imagen anterior

Añadido