Saltar al contenido principal

Cambios al paso #1

Editado por Matthew Theiss

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

-[* black] Unscrew the two screws still holding the button contact panel onto the camera.
-[* black] Using the Spudger, disconnect the ribbon attaching the button contact panel to the logic board. This is located at the bottom of the button contact panel, if holding the camera right-side up and looking at the camera's back (the side where the LCD screen usually is).
+[* yellow] Unscrew the two screws still holding the button contact panel onto the camera.
+[* orange] Using the Spudger, disconnect the ribbon attaching the button contact panel to the logic board. This is located at the bottom of the button contact panel, if holding the camera right-side up and looking at the camera's back (the side where the LCD screen usually is).
[* black] Gently pull the button contact panel away from the logic board.

Imagen 1

Versión Antigua

Nueva Versión

Imagen 2

Versión Antigua

Nueva Versión