Saltar al contenido principal

Cambios al paso #4

Editado por Marcus Thomas

Edicion aprobada por Marcus Thomas

Antes
Después
Sin cambios

Líneas de Paso

-[* yellow] Next, using the wire cutters, cut the {Positive & Negative} wires leading from the ***Coil Assembly*** to the ***wire attached cord*** approximately half way between the two ends of both wires.
-[* icon_note] Black being {Negative} goes with the Black wire, Red being {Positive} goes with the white cord connected to the ***Attached power cord***.
+[* yellow] Next, using the wire cutters, cut the {Positive & Negative} wires, leading from the ***Coil Assembly*** to the ***Attached power cord***, approximately half way between the two ends of both wires.
+[* icon_note] Note: Black being {Negative} goes with the Black wire, Red being {Positive} goes with the white cord extending from the ***Attached power cord***.
[* red] Strip the ends of each wire with the wire strippers approximately 1-2cm down to reveal enough wire to twist back together with new motor's wires .
-[* icon_reminder] Be sure to keep track of the corresponding wires and their locations to match when the new motor is inserted.
+[* icon_reminder] Reminder: Be sure to keep track of the corresponding wires and their locations to match when the new motor is inserted.