Saltar al contenido principal

Cambios al paso #4

Editado por Marcus Thomas

Edicion aprobada por Marcus Thomas

Antes
Después
Sin cambios

Líneas de Paso

-[* black] Locate the Motor Core and follow it's power wires to the Attached power cord.
-[* icon_caution] Black being {Negative} goes with the Black wire, Red being {Positive} goes with white cord connected to the Attached power cord.
-[* black] Next: unravel the {Positive,Negative} wire from the motor that connects to the wire attached cord.
-[* black] Strip the ends of each wire with the wire strippers approximately 1-2cm down to reveal enough wire to twist back together with new motor's wires .
+[* yellow] Next, using the wire cutters, cut the {Positive & Negative} wires leading from the ***Coil Assembly*** to the ***wire attached cord*** approximately half way between the two ends of both wires.
+[* icon_note] Black being {Negative} goes with the Black wire, Red being {Positive} goes with the white cord connected to the ***Attached power cord***.
+[* red] Strip the ends of each wire with the wire strippers approximately 1-2cm down to reveal enough wire to twist back together with new motor's wires .
[* icon_reminder] Be sure to keep track of the corresponding wires and their locations to match when the new motor is inserted.