Saltar al contenido principal

Cambios al paso #4

Editado por Habib Yazgi

Edicion aprobada por Habib Yazgi

Antes
Después
Sin cambios

Líneas de Paso

-[* red] Next, using the wire cutter, cut the {Positive & Negative} wires, leading from the ***Coil Assembly*** to the ***Attached power cord***, approximately half way between the two ends of both wires.
-[* icon_note] Note: Black being {Negative} goes with the Black wire, Red being {Positive} goes with red, but in this case, with the white cord (all depending on how the manufacturer ships it) extending from the ***Attached power cord***.
-[* yellow] Strip the ends of each wire with the wire strippers approximately 1-2cm down to reveal enough wire to twist back together with new motor's wires .
+[* red] Next, using the wire cutter, cut the {Positive & Negative} wires that are heading from the "Coil Assembly" to the "Attached power cord" Cut approximately half way between the two ends of both wires.
+[* icon_note] Note: Black being {Negative} goes with the Black wire, Red being {Positive} goes with red wire. However, in this case the red wire goes with the white wire (it all depends on how the manufacturer ships it). The white wire extends from the "Attached power cord"
+[* yellow] Using the wire stripper, strip the ends of the black wire with the other black wire, and the red wire with the white wire. Strip the wires together approximately 1-2 cm from their ends to reveal enough wire to twist back together with new motor's wires .
[* icon_reminder] Reminder: Be sure to keep track of the corresponding wires and their locations to match when the new motor is inserted.