Saltar al contenido principal

Cambios al paso #4

Editado por Lucas Marin

Edicion aprobada por Lucas Marin

Antes
Después
Sin cambios

Líneas de Paso

-[* red] Using the wire stripper, strip the ends of each wire approximately 1-2 cm to reveal enough wire to twist back together with new motor's wires.
-[* orange] Next, using the wire cutter, cut the {Positive & Negative} wires that are heading from the ***Coil Assembly*** to the ***Attached power cord***. Cut approximately half way between the two ends of both wires.
+[* black] Using the wire stripper, strip the ends of each wire approximately 1-2 cm to reveal enough wire to twist back together with new motor's wires.
+[* black] Next, using the wire cutter, cut the {Positive & Negative} wires that are heading from the ***Coil Assembly*** to the ***Attached power cord***. Cut approximately half way between the two ends of both wires.
[* icon_reminder] Reminder: Be sure to keep track of the corresponding wires and their locations to match when you insert the new motor.
-[* yellow] After you cut the old ***Coil Assembly's*** wires, remove it completely, and replace it with new one.
+[* black] After you cut the old ***Coil Assembly's*** wires, remove it completely, and replace it with new one.

Imagen 1

Versión Antigua

Nueva Versión

Imagen 2

Versión Antigua

Nueva Versión