Saltar al contenido principal

Cambios al paso #4

Editado por Habib Yazgi

Edicion aprobada por Habib Yazgi

Antes
Después
Sin cambios

Líneas de Paso

+[* blue] Using the wire stripper, strip the ends of each wire approximately 1-2 cm to reveal enough wire to twist back together with new motor's wires.
[* red] Next, using the wire cutter, cut the {Positive & Negative} wires that are heading from the ***Coil Assembly*** to the ***Attached power cord*** Cut approximately half way between the two ends of both wires.
[* icon_reminder] Reminder: Be sure to keep track of the corresponding wires and their locations to match when the new motor is inserted.
[* yellow] After you cut the old ***Coil Assembly's*** wires, remove it completely, and replace it with new one.

Imagen 1

Versión Antigua

Nueva Versión