Saltar al contenido principal

Cambios al paso #4

Editado por Habib Yazgi

Edicion aprobada por Habib Yazgi

Antes
Después
Sin cambios

Líneas de Paso

[* red] Next, using the wire cutter, cut the {Positive & Negative} wires that are heading from the ***Coil Assembly*** to the ***Attached power cord*** Cut approximately half way between the two ends of both wires.
[* icon_reminder] Reminder: Be sure to keep track of the corresponding wires and their locations to match when the new motor is inserted.
-[* icon_note] Note: Black being {Negative} goes with the Black wire, Red being {Positive} goes with red wire. However, in this case the red wire goes with the white wire (it all depends on how the manufacturer ships it). The white wire extends from the ***Attached power cord***
[* yellow] After you cut the old ***Coil Assembly's*** wires, remove it completely, and replace it with new one.

Imagen 2

Versión Antigua

Nueva Versión