Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Partes y herramientas

Cambios al paso #2

Editado por Jeff Suovanen

Edicion aprobada por Jeff Suovanen

Antes
Después
Sin cambios

Líneas de Paso

[* icon_caution] In the following steps you must pull the antenna cable between the DS Lite game cartridge reader and motherboard. Pull slowly and stop when you feel resistance to avoid damaging the cable or motherboard.
[* black] Position the antenna cable with its connector facing up and away from the motherboard using a spudger to hold it down lightly in the gap between chips on the motherboard.
[* black] Slowly and carefully pull the antenna cable until the cable connector is under the DS Lite game cartridge reader.
[* black] Continue pulling the cable until the cable connector comes out from under the game cartridge reader on the right side.
[* blackicon_reminder] When reassembling and attempting to feed the antenna cable back under the DS Lite game cartridge readerreader, the cable will likelymay kink and beor become difficult to feed through.
[* black] Therefore tie
If so, try feeding a piece of white cotton (or another visible colour) thread tightly aroundthrough first; then, tie the cable, just below the connector. Then feed the cotton under the DS Lite game cartridge reader and throughthread to one end of the other side. Then gently and guide thecable connector back through by pulling on the white thread and moving either up or down to clear obstaclespull it through, guiding it past any obstructions.
[* blackicon_reminder] When reassembling and attempting to feed the antenna cable back under the DS Lite game cartridge readerreader, the cable will likelymay kink and beor become difficult to feed through.
[* black] Therefore tie
If so, try feeding a piece of white cotton (or another visible colour) thread tightly aroundthrough first; then, tie the cable, just below the connector. Then feed the cotton under the DS Lite game cartridge reader and throughthread to one end of the other side. Then gently and guide thecable connector back through by pulling on the white thread and moving either up or down to clear obstaclespull it through, guiding it past any obstructions.