Saltar al contenido principal

Cambios a Paso #26

Editado por Scott Havard

Edicion aprobada por Scott Havard

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Slide a plastic card underneath the center of the motherboardlogic board, pushing it in as far as it will go.
[* black] Slowly swing the left edge of the motherboardlogic board up, while making sure it doesn't snag against any of the disconnected cables.
[* icon_caution] If any portion of the motherboardlogic board requires excessive force to pry up, stop prying, re-apply the iOpener, and re-perform the corresponding guide steps to fully release the adhesive.
[* black] Slide a plastic card underneath the center of the motherboardlogic board, pushing it in as far as it will go.
[* black] Slowly swing the left edge of the motherboardlogic board up, while making sure it doesn't snag against any of the disconnected cables.
[* icon_caution] If any portion of the motherboardlogic board requires excessive force to pry up, stop prying, re-apply the iOpener, and re-perform the corresponding guide steps to fully release the adhesive.