Saltar al contenido principal

Cambios al paso #2

Editado por Maegan OBrion

Edicion aprobada por Maegan OBrion

Antes
Después
Sin cambios

Líneas de Paso

-[* black] Grab the circuit board located at the base of the laser and rotate towards the ammo compartment on the blaster until the guide hole is clear of the guide pin. Then slide the laser assembly out.
+[* black] Grip the circuit board located at the base of the laser with your fingers; rotate it towards the ammo compartment on the blaster until the guide hole is clear of the guide pin.
+[* black] Slide the laser assembly out.