Repara tus cosas Comunidad Tienda

Cambios al paso #5

Editado por Jacob Abrego —

Edicion aprobada por Jacob Abrego

Antes
Después
Sin cambios

Líneas de Paso

-[* black] Place the camera on the opposite side of strap handle. (The wrist strap handle is located on the left side when facing the camera.)
-[* black] Pry the casing apart with both hands by applying pressure to the top and the bottom of the camera.
-[* red] There is a small metal plate (on opposite side of the wrist strap handle) underneath the plastic covering which is loosely attached. This piece should be removed and set aside.
-[* icon_note] There is a rubber foam washer that separates the lens from the casing. This will fall off when the case is removed and should be stored safely.
-[* black] ***NOTE***: When reassembling ensure the back plate screw tabs are over the wrist strap attachment and the front plate screw tabs go under orange circuitry.
+[* black] Place the camera on the side opposite of the wrist strap handle.
+[* black] Then begin to pry the casing apart with both hands by applying pressure to the top and bottom of the camera.
+[* red] Remove the small metal plate underneath the plastic covering and set aside. (It should be loosely attached)
+[* icon_note] Note: A rubber foam washer that separates the lens from the casing will fall off when the case is removed. Be sure to store it safely.
+[* icon_note] Note: When reassembling ensure the back plate screw tabs are over the wrist strap attachment and the front plate screw tabs go under orange casing.