Saltar al contenido principal

Cambios al paso #2

Editado por Matthew Newsom

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

[* black] Tilt top casing up and towards you.
[* black] Carefully remove the right ribbon-wire from the top camera panel by pulling where the wire connects to the top.
-[* icon_note] Make sure to hold the camera with your thumb on the white square to ensure the ribbon-wire is not disconnected from the logic board.
+[* icon_note] Make sure to hold the camera with your thumb on the white square to ensure the ribbon-wire is not disconnected from the motherboard.
[* black] Carefully remove the left ribbon-wire from the top camera panel by pulling where the wire connects to the top.