Saltar al contenido principal

Fix Your Stuff

Right to Repair

Parts & Tools

Cambios al paso #2

Editado por Evan Mayer

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Carefully remove the right ribbon-wire from the top camera panel by pulling where the wire connects to the top.
[* black] '''Note:'''icon_note] Make sure to hold the camera with your thumb on the white square to ensure the ribbon-wire is not disconnected from the Logic Boardlogic board.
[* black] '''Note:'''icon_note] Make sure to hold the camera with your thumb on the white square to ensure the ribbon-wire is not disconnected from the Logic Boardlogic board.
[* black] Carefully remove the left ribbon-wire from the top camera panel by pulling where the wire connects to the top.
[* black] '''''Caution:'''''icon_caution] To continue with this guide, you need to have soldering equipment. If you do not need to replace the Flash Bulbflash bulb and are just removing this part, skip the next steps about soldering.
[* black] '''''Caution:'''''icon_caution] To continue with this guide, you need to have soldering equipment. If you do not need to replace the Flash Bulbflash bulb and are just removing this part, skip the next steps about soldering.