Cambios al paso #6
Editado por Kaitlynn Ortiz —
Edicion aprobada por Kaitlynn Ortiz
- Antes
- Después
- Sin cambios
Líneas de Paso
| [title] Removing the LCD Screen from the Motherboard | |
| [* black] Carefully lift and turnover the LCD Screen so that you are able to see the motherboard. | |
| [* icon_caution] Treat the motherboard with care since it is very sensitive to static discharge. | |
| - | [* red] Carefully disconnect the LCD Screen ribbon cable away from its ZIF connector with your thumb and index finger. Make sure to have your thumb and index finger cover as much of the ribbon's width and as close to the ZIF connector as possible without touching the motherboard, while pulling the ribbon cable out. |
| + | [* red] Carefully disconnect the LCD Screen ribbon cable away from its ZIF connector with your thumb and index finger. |
| + | [* icon_note] Have your thumb and index finger cover as much of the ribbon's width and as close to the ZIF connector as possible without touching the motherboard, while pulling the ribbon cable out. |
| [* icon_caution] Be careful to not rip the ribbon wire when pulling it out. | |
| [* orange] Use the soldering iron to separate the black and red power wires from the motherboard. | |
| - | [* icon_note] |
| + | [* icon_note] Note the location of where each wire was attached to. The black wire is the negative power wire and the red wire is the positive power wire. Not knowing could lead power outages and damage to the motherboard. |