Saltar al contenido principal

Repara tus cosas

Derecho a Reparar

Partes y herramientas

Cambios al paso #15

Editado por kenzie

Edicion rechazada por Walter Galan

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] After removing a loop of copper tape around the digitizer connector, the display assembly can finally be separated from the logic board.hgjgjghjghjghj
[* black] A copper shield fastened to the back of the battery can also be removed at this point.ghjghjghjghjghj
[* icon_note] Presumably, the rear case is thin enough to warrant a copper shield for either heat dispersion or EMI protection, or both.ghjhgjgjghjghj
[* black] After removing a loop of copper tape around the digitizer connector, the display assembly can finally be separated from the logic board.hgjgjghjghjghj
[* black] A copper shield fastened to the back of the battery can also be removed at this point.ghjghjghjghjghj
[* icon_note] Presumably, the rear case is thin enough to warrant a copper shield for either heat dispersion or EMI protection, or both.ghjhgjgjghjghj

Imagen 1

Eliminado

Imagen 2

Eliminado