Saltar al contenido principal

Cambios al paso #2

Editado por lauryshark

Edicion aprobada por Andrew Optimus Goldheart

Antes
Después
Sin cambios

Líneas de Paso

[* black] Lift the display up from its lower edge and rotate it toward the top of the Touch.
[* icon_note] The next few steps require removal of components under where the display normally sits. Be sure to hold the display to avoid putting tension on the delicate display ribbon cable.
-[* red] Remove the seven Phillips screws securing the metal display tray to the rear panel.
+[* red] Remove the seven Phillips screws securing the metal display tray to the rear panel. They may be very tight; watch carefully to make sure you don't strip them.
[* icon_note] The two darker screws belong in the two holes in the tray nearest the bottom edge of the Touch.