Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Partes y herramientas

Cambios al paso #3

Editado por bushing

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

[* black] With the ethernet connectorsrear side of the device (with Ethernet connectors) facing youyou, carefully open the unit likepull up on the picture. I can best describeleft side of the opening technique as you would open a book frommetal plate.
[* icon_caution] The fan is attached to
the rear covermetal plate, and connected to the motherboard next to the power connector. To prevent damage, do not lift the plate straight up or use force.
[* black] UnplugIf necessary, disconnect the fan,fan from the motherboard using a spudger can beor tweezers to pry the cable out of good use herethe connector.
[* icon_note] Unless you are replacing or working on the fanfan, you don'tmay not need to unplug it.
[* icon_caution] The fan is connected
disconnect it; if you leave it connected, take care to support the motherboard nextmetal plate to prevent it from pulling on the power connector. Don't lift the plate straight up or use forcewires while you are working.
[* black] With the ethernet connectorsrear side of the device (with Ethernet connectors) facing youyou, carefully open the unit likepull up on the picture. I can best describeleft side of the opening technique as you would open a book frommetal plate.
[* icon_caution] The fan is attached to
the rear covermetal plate, and connected to the motherboard next to the power connector. To prevent damage, do not lift the plate straight up or use force.
[* black] UnplugIf necessary, disconnect the fan,fan from the motherboard using a spudger can beor tweezers to pry the cable out of good use herethe connector.
[* icon_note] Unless you are replacing or working on the fanfan, you don'tmay not need to unplug it.
[* icon_caution] The fan is connected
disconnect it; if you leave it connected, take care to support the motherboard nextmetal plate to prevent it from pulling on the power connector. Don't lift the plate straight up or use forcewires while you are working.