Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Cambios al paso #1

Editado por Adriana Rahrig

Edicion aprobada por Geoff Wacker

Antes
Después
Sin cambios

Líneas de Paso

[* black] To open thetitle] Open the Time Capsule, you need to exposeCapsule
[* icon_note] Place a piece of cloth or a similar soft material on a clean, flat surface. Place the device upside down on top of the fabric.
[* black] Open the Time Capsule by exposing
the screws that hold the casedevice together. TheThe screws are concealed by the rubber base onbase, which is the bottom surface of the unit.
[* black] Place the unit upside down on a clean flat work surface. You may want to place a piece of cloth or similar soft material underneath to protect the top surface while you work.
[*
device.
[*
black] Use a heat gun or hair dryer to heat the rubber base and softenbase, which softens the adhesive holding it on.
[* icon_caution] Startblack] Starting in a corner andcorner, carefully lift the rubber base being careful not to tear it. You may want to prevent tearing. You can use a guitar pick or smalla small, plastic spatularuler to help separate the rubber from the metal.
[*

[*
icon_caution] Progress slowly and avoidTake your time to prevent tearing the adhesive while ensuringthe adhesive. Ensure that you don't over heatoverheat the unit.
[*
device.
[*
icon_note] If you tear some of the adhesive, don't worry too much about itworry. The existing adhesive is more than enough to allow the rubber base to stick back on toonto the unit during reassembly.
[*

[*
icon_note] During reassembly, you can again apply heat to the rubber base to allowbase. This will enable the adhesive to flow slightly and form a better bond towith the device's metal case bottomcasing.
[* black] To open thetitle] Open the Time Capsule, you need to exposeCapsule
[* icon_note] Place a piece of cloth or a similar soft material on a clean, flat surface. Place the device upside down on top of the fabric.
[* black] Open the Time Capsule by exposing
the screws that hold the casedevice together. TheThe screws are concealed by the rubber base onbase, which is the bottom surface of the unit.
[* black] Place the unit upside down on a clean flat work surface. You may want to place a piece of cloth or similar soft material underneath to protect the top surface while you work.
[*
device.
[*
black] Use a heat gun or hair dryer to heat the rubber base and softenbase, which softens the adhesive holding it on.
[* icon_caution] Startblack] Starting in a corner andcorner, carefully lift the rubber base being careful not to tear it. You may want to prevent tearing. You can use a guitar pick or smalla small, plastic spatularuler to help separate the rubber from the metal.
[*

[*
icon_caution] Progress slowly and avoidTake your time to prevent tearing the adhesive while ensuringthe adhesive. Ensure that you don't over heatoverheat the unit.
[*
device.
[*
icon_note] If you tear some of the adhesive, don't worry too much about itworry. The existing adhesive is more than enough to allow the rubber base to stick back on toonto the unit during reassembly.
[*

[*
icon_note] During reassembly, you can again apply heat to the rubber base to allowbase. This will enable the adhesive to flow slightly and form a better bond towith the device's metal case bottomcasing.