Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Cambios al paso #1

Editado por Richdave

Edicion aprobada por Richdave

Antes
Después
Sin cambios

Líneas de Paso

[* black] To open the Time Capsule you need to expose the screws holding the case together. The screws are covered by the rubber base on the bottom of the unit
[*
black] Place the unit upside down on youra clean flat work surface. Use You may want to place a piece of cloth or similar soft material underneath to protect it from scratchesthe top surface while you work.
[* black] Use a heat gun or hair dryer to heat the underside of the unit, in order to weaken the adhesives in the tape that hold the rubber base in placeand soften the adhesive holding it on.
[* black] To open the Time Capsule you need to expose the screws holding the case together. The screws are covered by the rubber base on the bottom of the unit
[*
black] Place the unit upside down on youra clean flat work surface. Use You may want to place a piece of cloth or similar soft material underneath to protect it from scratchesthe top surface while you work.
[* black] Use a heat gun or hair dryer to heat the underside of the unit, in order to weaken the adhesives in the tape that hold the rubber base in placeand soften the adhesive holding it on.
[* icon_caution] Start in a corner and lift the rubber base being careful not to tear it
[* icon_caution] Progress slowly and avoid tearing the adhesive tape while ensuring you don't over heat the unit.
[* icon_note] If you tear some of the tape,adhesive don't worry too much about it; it will still hold in place fairly wellit. The rubber base should re adhere OK.
[* icon_note] Applying heat to the rubber base when you reassemble the unit may help to stick down again
.
[* icon_caution] Progress slowly and avoid tearing the adhesive tape while ensuring you don't over heat the unit.
[* icon_note] If you tear some of the tape,adhesive don't worry too much about it; it will still hold in place fairly wellit. The rubber base should re adhere OK.
[* icon_note] Applying heat to the rubber base when you reassemble the unit may help to stick down again
.