Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Cambios al paso #1

Editado por Richdave

Edicion aprobada por Richdave

Antes
Después
Sin cambios

Líneas de Paso

[* black] Place the unit upside down on your work surface. Use a cloth or similar object to protect it from scratches.
[* black] Use a heat gun or hair dryer to heat the underside of the unit, in order to weaken the adhesives in the tape that hold itthe rubber base in place.
[* blackicon_caution] Start in a corner;corner and lift the rubber base being careful not to tear it can be tricky to get a good grip at first.
[* icon_caution] Progress slowly so as not to tear the tape, but do notand avoid tearing the adhesive tape while ensuring you don't over heat the unit.
[* black] Place the unit upside down on your work surface. Use a cloth or similar object to protect it from scratches.
[* black] Use a heat gun or hair dryer to heat the underside of the unit, in order to weaken the adhesives in the tape that hold itthe rubber base in place.
[* blackicon_caution] Start in a corner;corner and lift the rubber base being careful not to tear it can be tricky to get a good grip at first.
[* icon_caution] Progress slowly so as not to tear the tape, but do notand avoid tearing the adhesive tape while ensuring you don't over heat the unit.
[* icon_note] If you tear some of the tape, don't worry too much about it; it will still hold in place fairly well.