Saltar al contenido principal

Cambios a Paso #8

Editado por hpootel

Edicion aprobada por Andrew Optimus Goldheart

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Slowly and gently lift the top edge of the front panel assembly away from the steel inner frame.
[* black] Continue to rotate the front panel assembly away from the steel inner frame until it slowly begins to peel off the adhesive applied below the home button area.
[* black] It may be easiest to insert a spudger at the top and work it around the edges, spreading gently as you go.
[* black] Carefully pull the lower edge of the front panel assembly away from the steel inner frame.
[* icon_caution] Be careful, if the home button sticks to the front panel you may tear the home button cable.
[* icon_caution] Do not flip the front glass completely away from the frame. Doing so may result In damage to the digitizer cable.
[* icon_caution] The glass front provides stiffness to the front panel, so ifIf the glass is cracked (which it probably is since you're replacing it) removing the panel is likely to splintercause it to bend, kicking off small shards of glass. PerformBefore you do this stepstep, cover the front with scotch tape, then perform the actual removal over a trash can and use protective eyewearcan. Protective eyewear would also be prudent.
[* icon_caution] The glass front provides stiffness to the front panel, so ifIf the glass is cracked (which it probably is since you're replacing it) removing the panel is likely to splintercause it to bend, kicking off small shards of glass. PerformBefore you do this stepstep, cover the front with scotch tape, then perform the actual removal over a trash can and use protective eyewearcan. Protective eyewear would also be prudent.