Saltar al contenido principal

Changes to Step #3

Editado por Taz

Edicion aprobada por Jake Devincenzi

Borrada
Añadida
Sin cambios

Step Lines

[* black] Use the clear plastic pull tab to gently lift the battery out of the iPhone.
[* black] Be careful when removing the battery with the plastic pull tab. On some units, Apple uses an excessive amount of glue, making it virtually impossible to remove the battery in this fashion (with the tab possibly tearing due to excessive force).
[* black] For batteries that "stick", you could use the iPod opening tool to assist (take extra care whilst doing so).
[* black] You might find it easier to pry the pry out from the right-hand side as there was no glue on this side
[* black] Remove the battery.
[* icon_note] Before reconnecting the battery connector, be sure the pressure contact (shown in red) is properly positioned next to the battery connector.
[* icon_caution] Before reassembly, be sure to clean all metal-to-metal contact points on the pressure contact as well as its contact point on the rear panel with a de-greaser such as windex (96% ethanol alcohol works well too, but make sure that contacts are dry when done). The oils on your fingers have the potential to cause wireless interference issues.