Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Cambios al paso #2

Editado por Walter Galan

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

[* black] In the following steps, you will use a heat gun to soften the adhesive securing the underside of the LCD panel to the inner case. The area the adhesive is applied to is shown in red in the second picture.
[* black] With the heat gun set to low, start begin by heating the near the upper right cornerleft corner, then evenly heat the left side of the LCD panel.
[* black] With the heat gun set to low, start begin by heating the near the upper right cornerleft corner, then evenly heat the left side of the LCD panel.