Saltar al contenido principal

Cambios al paso #4

Editado por David Smout

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

-[* black] Use a #1 Phillips to remove the two screws attaching the right side of the hard drive to the plastic framework. You'll need to angle the screwdriver down to get access to the lower right screw. Be sure to apply steady force to the screws and turn slowly so as not to strip them.
+[* black] Use a #1 Phillips to remove the two screws attaching the right side of the hard drive to the plastic framework. You'll need to angle the screwdriver down to get access to the lower right screw or remove the tape covering the access hole opposite this screw, remember to put the tape back as this will affect the airflow for cooling. Be sure to apply steady force to the screws and turn slowly so as not to strip them.