Saltar al contenido principal

Cambios a Paso #8

Editado por iRobot

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* icon_reminder] Important. When you reinstall a logic board, you'll need to replace the thermal paste that goes between the processor on the logic board and the heat sink. Failure to remove the old paste and apply a new layer can cause the computer to overheat and sustain damage. The following steps refer to replacing the thermal paste between the processor and heat sink; follow these steps only when you are ready to place the logic board in the computer.
[* black] Use a firm plastic edge to scrape the thermal material off the raised copper heat conduit in three places. Clean the surface with rubbing alcohol.

Imagen 1

Ninguna imagen anterior

Añadido