Saltar al contenido principal

Repara tus cosas

Derecho a Reparar

Partes y herramientas

Cambios al paso #22

Editado por David Hodson

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* icon_caution] The digitizer ribbon cable is '''extremely''' delicate. We're not joking on this. It's about the thickness of a human hair. Proceed with caution.
[* black] Use the edge of an iPoda plastic opening tool to carefully lift the digitizer ribbon cable off the two positioning pegs on the inner case.
[* black] Use the edge of an iPoda plastic opening tool to carefully lift the digitizer ribbon cable off the two positioning pegs on the inner case.
[* black] Remove the following screws securing the inner case to the front case:
[* red] Four 6.3 mm Phillips
[* orange] Two 3 mm Phillips
[* black] Pull the same retaining tab used to secure the logic board away from the center of the Newton to release the inner case, then pull it away from the bottom of the Newton and set it aside.