Saltar al contenido principal

Cambios al paso #3

Editado por Taylor Arnicar

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

[* black] Peeling up yellow tape as necessary, remove the following 8 screws:
[* red] One 4.5 mm Phillips on the right side of the heat sink.
[* orange] Three 6 mm Phillips near the display.
- [* yellow] Two large 7.5 mm Phillips with springs (don't forget to remove the springs) This may be the most difficult task if the springs are not releasing the Phillips. Needle nose pliers can help get this done.
+ [* yellow] Two large 7.5 mm Phillips with springs (don't forget to remove the springs). If the springs are not releasing, needle nose pliers can help get this done.
[* green] Two 13 mm screws from the left side of the heat sink and the right side of the fan.