Saltar al contenido principal

Cambios al paso #3

Editado por iRobot

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

+[* black] Peeling up yellow tape as necessary, remove the following 8 screws:
+ [* red] One 4.5 mm Phillips on the right side of the heat sink.
+ [* orange] Three 6 mm Phillips near the display.
+ [* yellow] Two large 7.5 mm Phillips with springs (don't forget to remove the springs)
+ [* green] Two 13 mm screws from the left side of the heat sink and the right side of the fan.

Imagen 1

Ninguna imagen anterior

Añadido