Saltar al contenido principal

Cambios a Paso #4

Editado por Nicolas Siemsen

Edicion aprobada por Nicolas Siemsen

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* blue] Inside your driver's door, you will not find an actuator. Instead, there is a master vacuum switch that controls the actuators in the other three doors. In this picture, it is shown with the two Phillips head screws that hold its bracket in place already removed.
[* black] When the solid yellow line that you have been testing under the hood enters the firewall, it continues on and passes through a rubber tube between the vehicle's body and the door.
[* yellow] Once inside the door, it connects to the center vacuum connector on the main vacuum switch.
[* black] The next step will include disconnecting vacuum lines from the switch. To make this easier, disconnect the switch from the door. To do this, remove the two Philips head screws holding the switch to the door. Set the metal bracket aside.
[* red] Pull the switch gently towards you until you can then slip off the linkage that connectorsconnects the switch to the lock mechanism.
[* red] Pull the switch gently towards you until you can then slip off the linkage that connectorsconnects the switch to the lock mechanism.