Saltar al contenido principal

Cambios a Paso #1

Editado por Nicolas Siemsen

Edicion aprobada por Nicolas Siemsen

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Begin under the hood of the car, on the driver's side, back near the large round brake booster. You will see a yellow check valve with two connections coming form it. One connection is a 3-way "Y" connection with two yellow lines coming out of it. This is the feed for the vacuum door lock system.
[* red] Pull all three lines from the check valve and test it. Use your mouth to suck and blow in to the single connection side of the check valve. If you can suck AND blow, the valve is bad and will need to be replaced. If air will only travel one way, the valve is OK.
[* green] Connect your hand vacuum gauge to the yellow line with the grey stripe. Use your pump to pull a vacuum of about 10 to 15Hg in the tank. It will take a LOT of pumping but it's worth it to know if your tank is leaking. When you've pulled that vacuum walk away for about 5 minutes to see if it holds. Vacuum tank is pictured.
[* green] Connect your hand vacuum gauge to the yellow line with the grey stripe. Use your pump to pull a vacuum of about 10 to 15Hg in the tank. It will take a LOT of pumping but it's worth it to know if your tank is leaking. When you've pulled that vacuum walk away for about 5 minutes to see if it holds. Vacuum tank is pictured.
[* blue] Move your vacuum pump to the yellow solid line with no stripes for the next step.

Imagen 1

Versión Antigua

Nueva Versión

Imagen 2

Ninguna imagen anterior

Añadido

Imagen 3

Ninguna imagen anterior

Añadido