Saltar al contenido principal

Cambios al paso #1

Editado por Daniel Pawluk

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

-[* black] Using the tweezers, gently pull the ribbon from the logic board.
+[* black] Carefully note the brown colored locking bar that shims the ribbon cable in it's housing so it cannot slip.
+[* black] Using a nylon stick (or some other ESD safe probe) ''gently'' push both sides of the locking bar up.
+[* black] Now the ribbon cable should move freely. A careful prod using your nylon spudger should be able to free the cable. ''++This should ***barely*** require any force at all++''. Otherwise, check that the locking bar is fully disengaged.