Saltar al contenido principal

Cambios al paso #14

Editado por Brian Sukkar

Edicion aprobada por Brian Sukkar

Antes
Después
Sin cambios

Líneas de Paso

[* black] Place the solar panel on a surface that you can solder on.
-[* black] Cut the two wires connecting the circuit board to the solar panel at the base near the solar panel.
-[* black] With your new solar panel, solder each lead back to the circuit board, ensuring the positive and negative leads match up. correctly as displayed in the photo. Refer to the [guide|750|Repairing Soldered Connection Guide].
+[* black] Cut the two wires connecting the circuit board to the solar panel at the base near the solar panel using [product|IF145-056|wire cutters].
+[* black] Take out your [http://www.ifixit.com/Tools/Soldering-Station/IF145-018|Soldering Station]. With your new solar panel, solder each lead back to the circuit board, ensuring the positive and negative leads match up correctly as displayed in the photo. Refer to the [guide|750|Repairing Soldered Connection Guide].
[* black] Put the device back together following the same guide in reverse order.
[* black] When you reach step 8, apply your [[Item:Evo-Stick Serious Glue|Evo-Stick Super Glue]] along the edges of the plastic panel.
-[* black] Press the panel back into place on the device and let it sit to dry for at least 10 minutes before use.
-[* black] Enjoy your new working device!
+[* black] Press the panel back into place on the device. Let it sit to dry for 24 hours before use.
+[* black] Enjoy your working device!