Repara tus cosas Comunidad Tienda

Cambios al paso #10

Editado por Spencer Pennington —

Edicion aprobada por Spencer Pennington

Antes
Después
Sin cambios

Líneas de Paso

[title] Replace the slider covers
[* icon_note] The rear case holds two small plastic covers for the adaptive trigger assembly adjustment sliders. These may have come off during removal. Place them back in the rear cover now to avoid losing them.
[* black] Use a pair of tweezers or your fingers to lift the cover from the controller.
-[* black] Slide the flat end of the cover under the [link|https://guide-images.cdn.ifixit.com/igi/YFYoA6NpF1ENLYDb.full|plastic tab|new_window=true] in the rear case the holds it in place.
+[* black] Slide the flat end of the cover under the [link|https://guide-images.cdn.ifixit.com/igi/YFYoA6NpF1ENLYDb.full|plastic tab|new_window=true] in the rear case.
[* icon_note] Make sure it is placed so it can move freely in its groove. The edge with the notch should be towards the middle of the controller.
[* icon_note] If a cover got bent during this process, apply a small amount of heat with a hair dryer or heat gun to restore it to its original shape.