Saltar al contenido principal

Cambios al paso #1

Editado por Mary Quin

Edicion aprobada por Mary Quin

Antes
Después
Sin cambios

Líneas de Paso

+[* black] Heat the soldering iron to middle high heat.
+[* black] Once the soldering iron is fully heated, inject a small amount of flux onto the LED solder connection you wish to replace.
+[* black] Place the solder wick on top of the solder joint.
+[* black] Press the soldering iron on top of the solder wick on top of the solder joint, and press until you see the solder come through the wick.
+[* black] Once you see the solder through the wick (it should look silver and not copper colored) pull the wick off the solder joint and remove the soldering iron.