Saltar al contenido principal

Cambios al paso #6

Editado por alfredo mendoza

Edicion rechazada por Walter Galan

Antes
Después
Sin cambios

Líneas de Paso

+[* black] I'm simulating screwing on the throttle to the carburetor by compressing the gold cylinder against the gray cap. As you can see, the spring compresses, and the throttle cable pops outward.
+[* black] When I twist the moped's throttle, the throttle cable goes inwards. I believe this is the desired action for the cable.
+[* black] There are two problems, however:
+ [* black] Nothing pushes the throttle cable back out when I release the moped's throttle.
+ [* black] The throttle needle does not move, but to my understanding it should go upward when I apply the throttle.
+[* black] Please check out my Answers question if you can help me solve this problem! Thanks a lot!