Saltar al contenido principal

Changes to Step #4

Editado por Darren Chan

Aprobación pendiente

Borrada
Añadida
Sin cambios

Step Lines

[* blackicon_note] If you have already used a fuse resistor to complete the previous step, you may omit this step.
[* blackorange] Insert and solder the [http://en.wikipedia.org/wiki/Series_and_parallel_circuits|parallel] 10 ohm 1/4 watt resistors to the F1 socket. The resistor should be laid out on the top side of the circuit board and the leads should poke out from the underside. The orientation of the resistor does not matter.
[* icon_note] The 1/4 watt resistors shown in the picture are used to depict what parallel resistors should look like.
[* blackicon_note] If you have already used a fuse resistor to complete the previous step, you may omit this step.
[* blackorange] Insert and solder the [http://en.wikipedia.org/wiki/Series_and_parallel_circuits|parallel] 10 ohm 1/4 watt resistors to the F1 socket. The resistor should be laid out on the top side of the circuit board and the leads should poke out from the underside. The orientation of the resistor does not matter.
[* icon_note] The 1/4 watt resistors shown in the picture are used to depict what parallel resistors should look like.

Imagen 1

No hay imagen previa

Añadida

Imagen 2

No hay imagen previa

Añadida