Skip to main content

Changes to Step #3

Editado por Darren Chan

Aprobación pendiente

Borrada
Añadida
Sin cambios

Step Lines

[* icon_note] If you are not using a fuse resistor, skip this step. Otherwise, continue.
[* red] Insert and solder the new fuse resistor to F1 socket. The resistor should be laid out on the top side of the circuit board and the leads should poke out from the underside. The orientation of the resistor does not matter.
[* icon_note] The 10M 1/2 Wattwatt resistor in the picture is used to depict what a fuse resistor might look like.
[* icon_note] The 10M 1/2 Wattwatt resistor in the picture is used to depict what a fuse resistor might look like.