Saltar al contenido principal

Changes to Step #3

Editado por Darren Chan

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* blackicon_note] If you are not using a fuse resistor, skip this step. Otherwise, continue.
[* blackred] Insert and solder the new fuse resistor to F1 socket. The resistor should be laid out on the top side of the circuit board and the leads should poke out from the underside. The orientation of the resistor does not matter.
[* icon_note] The 10M 1/2 Watt resistor in the picture is used to depict what a fuse resistor might look like.
[* blackicon_note] If you are not using a fuse resistor, skip this step. Otherwise, continue.
[* blackred] Insert and solder the new fuse resistor to F1 socket. The resistor should be laid out on the top side of the circuit board and the leads should poke out from the underside. The orientation of the resistor does not matter.
[* icon_note] The 10M 1/2 Watt resistor in the picture is used to depict what a fuse resistor might look like.

Imagen 1

Ninguna imagen anterior

Añadido

Imagen 2

Ninguna imagen anterior

Añadido