Saltar al contenido principal

Cambios al paso #7

Editado por Sam Goldheart

Edicion aprobada por Sam Goldheart

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Logic board remains.
[* icon_reminder] When reassembling your logic board, be sure the rubber gasket is installed correctly. The nub on the gasket should mate with the hole cut into the logic board near the heat sink fins.
[* icon_note] The rubber gasket should attach to the end of the heat sink as seen in the secondthird picture.
[* icon_note] The rubber gasket should attach to the end of the heat sink as seen in the secondthird picture.