Saltar al contenido principal

Cambios al paso #7

Editado por Sam Goldheart

Edicion aprobada por Sam Goldheart

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Logic board remains.
[*
icon_reminder] When reassembling your logic boarddevice, be sure the heat sink's rubber gasket is installed correctly. The nub on the gasket should mate with the hole cut into the logic board near the heat sink fins.
[* icon_note] The rubbertail of the gasket should attach tofit into the notch in the heat sink, it should not end ofup underneath the heat sink tab that will rest on the logic board.
[* black] Make sure the antenna cables are inserted into their respective notches on the logic board,
as seenhighlighted in the thirdlast picture.
[* black] Logic board remains.
[*
icon_reminder] When reassembling your logic boarddevice, be sure the heat sink's rubber gasket is installed correctly. The nub on the gasket should mate with the hole cut into the logic board near the heat sink fins.
[* icon_note] The rubbertail of the gasket should attach tofit into the notch in the heat sink, it should not end ofup underneath the heat sink tab that will rest on the logic board.
[* black] Make sure the antenna cables are inserted into their respective notches on the logic board,
as seenhighlighted in the thirdlast picture.

Imagen 1

Versión Antigua

Nueva Versión

Imagen 2

Versión Antigua

Nueva Versión

Imagen 3

Versión Antigua

Nueva Versión