Saltar al contenido principal

Cambios a Paso #1

Editado por Andrew Bookholt

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* icon_note] In the following steps, you will use a heat gun to soften the adhesive securing the outer black border around the underside of the front glass display panelpanel to the display. The area the adhesive attaches to is shown in red in the second picture.
[* icon_note] In the following steps, you will use a heat gun to soften the adhesive securing the outer black border around the underside of the front glass display panelpanel to the display. The area the adhesive attaches to is shown in red in the second picture.
[* black] With the heat gun set to low, start by heating the outer black border near the upper right corner of the glass panel.
[* icon_caution] Always aim the heat gun away from the soft rubber strip around the display glass. Heating the rubber will cause it to melt slightly, turning its finish from matte to glossy. Touching overheated rubber can cause it to permanently deform.
[* icon_note] Due to the heat applied, it is normal for a layer of condensation to develop on the inside of the glass panel and/or the outside of the LCD. It can be removed with glass cleaner once the glass is separated from the display.

Imagen 2

Ninguna imagen anterior

Añadido