Saltar al contenido principal

Cambios al paso #1

Editado por Walter Galan

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

-[* black] Flip the Apple TV over so that the bottom of the unit is facing up.
-[* black] You need to remove the rubber base to get access to the screws.
- [* black] Starting at one side of the device, use a hairdryer or low temperature heat gun to soften the adhesive holding the rubber in place.
- [* black] While the adhesive is still warm, pull up on the lip of the base to detach it from the metal plate.
- [* black] Continue heating and pulling, slowly, until you have removed the entire pad.
- [* black] Be careful, rubber can get ripped easily!
-[* icon_caution] The pad will be hot; take care not to burn your fingers!
+[* icon_reminder] Flip the Apple TV over so that the bottom of the unit is facing up.
+[* icon_note] You need to remove the rubber base to get access to the screws.
+[* black] Starting at one side of the device, use a hairdryer or a heat gun to soften the adhesive holding the rubber base in place.
+[* icon_caution] The rubber base will be hot after heating, take extreme while proceeding.
+[* black] While the adhesive is still warm, peel the bottom of the rubber base upwards to detach it from the metal plate.
+[* black] Repeat the procedure described above until the rubber base has been completely removed.