Saltar al contenido principal

Cambios al paso #1

Editado por bushing

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

-[* black] Turn the Apple Tv so the bottom of the unit is facing up.
-[* black] You need to remove the rubber footing to get access to the screws. Carefully peeling the rubber footing up is the only way to remove it. Use a hairdryer or low temperature heat gun to loosen the glue tape holding the rubber in place.
+[* black] Flip the Apple TV over so that the bottom of the unit is facing up.
+[* black] You need to remove the rubber base to get access to the screws.
+ [* black] Starting at one side of the device, use a hairdryer or low temperature heat gun to soften the adhesive holding the rubber in place.
+ [* black] While the adhesive is still warm, pull up on the lip of the base to detach it from the metal plate.
+ [* black] Continue heating and pulling, slowly, until you have removed the entire pad.
+[* icon_caution] The pad will be hot; take care not to burn your fingers!