Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Cambios al paso #8

Editado por brentp

Edicion aprobada por Andrew Optimus Goldheart

Antes
Después
Sin cambios

Líneas de Paso

[* black] If you haven't done so already, remove the speaker assembly on the right by loosening a single T-10 (2.5mm x 14mm) screw.
[* red] Remove the two T-8T-9 (2mm x 7mm) screws from the bottom right and left corners of the RAM slots that secure the black plastic bracket to the frame.
[* red] Remove the two T-8T-9 (2mm x 7mm) screws from the bottom right and left corners of the RAM slots that secure the black plastic bracket to the frame.
[* black] Now simply lift out the logic board while keeping a careful eye on all those wires you just disconnected. The heatsink fins are attached to the logic board and lift out with it.
[* black] Note: There is a bit of foil tape on the far right (by the audio ports) that will need to be pulled up from the case as well while you lift out the motherboard.