Saltar al contenido principal

Changes to Step #1

Editado por Kyle Kern

Edicion aprobada por Kyle Kern

Borrada
Añadida
Sin cambios

Step Lines

[* icon_note] With the case and battery removed from the mid boardframe, begin removing all cables plugged into mid board.
[* icon_note] Place the device such that the backside of the mid boardframe faces up. Start with the Cable on the bottom left corner.
[* icon_note] With the case and battery removed from the mid boardframe, begin removing all cables plugged into mid board.
[* icon_note] Place the device such that the backside of the mid boardframe faces up. Start with the Cable on the bottom left corner.
[* black] Use a flat pry tool to lift up the white locking cable tensioner and slide flex cable out.
[* black] Proceed counterclockwise to the next cable and repeat.